Last Week’s Craft
Supplies
- White, Brown, Yellow, Orange, Green and Blue Cardstock
- Glue and Scissors
Instructions
- Glue mountain onto blue cardstock
- Glue the flat cardstock to create the clouds, snow capped mountain, and flowers.
- Glue the partially folded cardstock on top of these elements to create a 3D effect.
Supplies
- White, Brown, Yellow, Orange, Green and Blue Cardstock
- Glue and Scissors
Instructions
- Glue mountain onto blue cardstock
- Glue the flat cardstock to create the clouds, snow capped mountain, and flowers.
- Glue the partially folded cardstock on top of these elements to create a 3D effect.
Supplies
- cardstock
- paper plate
- popsicle stick
- glue
Instructions
- Glue the blue cardstock on either side of the folded paper plate, leaving about an inch or so above the fold of the plate.
- Glue the blue construction paper to the blue cardstock to form the waves.
- Glue the brown cardstock to the wooden stick, leaving about a 1/2 inch from the bottom.
- Glue the yellow circles on the boat.
- Glue the sails on either side of the stick.
- Place the stick inside the hole in the middle of the fold.
- The boat should be tucked inside the cardstock so that it looks like it is in the water.
Supplies
- Straws
- Felt
- Elastic
- Pipe Cleaner
- 1 large googly-Eye
- Tape/Glue
Instructions
- Thread pipe cleaner through the back of the hole in the mouth of the fish, leaving about 1/4 of an inch out.
- Fold the tip of the pipe cleaner back toward the hole to create the mouth of the fish.
- Tape the pipe cleaner to the back of the mouth near the opposite end of the mouth.
- Begin threading the straws on the pipe cleaner, alternating the large and the small straws.
- Secure the pipe cleaner to the fin of the fish with tape.
- Tape the elastic to the back of the fin and the head of the fish.
- Glue the round felt piece to the head.
- Glue the googly-eye to the round piece felt.
Last Week’s Craft
Supplies
- Cardstock
- Pom-Poms
- Crepe Paper
- Wiggly Eyes
- Glue/Tape/Stapler
Instructions
Make a cylinder out of the large black cardstock. Staple to secure.
Glue the white cardstock to form the penguin’s belly.
Next, glue the purple strips around the middle of the cylinder, adding the smaller purple strips on top of the longer purple strip to form the belt.
Glue the eyes, beak, and pompoms on the penguin’s head.
Glue the yellow strip on the inside of the cylinder.
Finally, glue or tape the black crepe paper strips to the inside of the bottom of the penguin’s body.